ALL WELDS CONTINUOUS UNLESS OTHERWISE STATED. 未注焊缝均为连续焊
ALL WELDS 3mm FILLET UNLESS OTHERWISE STATED 未注焊角高3mm.
ALL UNSPECIFIED RADI - R3 未注圆角R3
REMOVE ALL BURRS AND SHARP EDGES 所有尖角/棱角倒角并去毛
11 TOTAL COILS APROX.9 WORKING COILS APROX.RIGHT HAND WOUND ONLY,END COILS SQUARE TO TOUCH.总圈数约11圈；工作圈数约9圈；右旋；弹簧的端部磨平以便于接触.(此为弹簧技术说明)
CHANNEL 槽钢
RSA 708 角钢 70X70X8
M30X1.5 pitch M30X1.5的锥螺纹
Tackweld 点焊
OD 1/4" outside dimension 1/4"的缩写 外径直1/4"
75 CRS 尺寸为75 材质为冷轧钢板
410 OPENING REF 410 开口参考尺寸
40 REF 尺寸为40,参考值
2.5" BSP 2.5” 圆锥管螺纹
2.5" BSPT HEXAGON 2.5” 六角圆锥管螺纹(即对丝)
30x2.5 FLAT BAR 30X2.5 扁钢
TYP 2 POSNS 2处
FEMALE: 内扣(母扣)
MALE: 外扣(公扣)
eccentric shaft 偏心轴
PIN 销轴
COTTER PIN 开口销
screw 螺杆
axletree 轴承
closing ring 挡圈
circlip 弹性挡圈
SPRING 弹簧
SET SCREW 紧定螺钉
ROUND NUT 圆螺母
FLAT KEY 平键
ROUND NUT 圆螺母
HEX HD BOLT 六角螺栓
non-buckle longth 无扣长
FLAT WASHER 平垫圈
FULL NYLOCK NUT 螺母
LIFTING EYE BOLT 吊环螺钉
SOCKET HEAD CAP SCREW 内六角螺钉
HEX HD SETSCREW 六角螺钉
distance sleeve of axletree 轴承隔套
DEEP GROOVE BALL BEARING 深沟球轴承
SLOTTED PAN HEAD SCREW 开槽盘头螺钉
TAPERED ROLLER BEARING 圆锥滚子轴承
THRUST BALL BEARING 推力球轴承
SINGLE COIL SPRING WASHER 弹簧垫圈